How to assemble
1. Insert Wand into Floor Nozzle.
2. Insert Handle into wand.
3. Place Pod onto wand and slide down to connect.
4. Connect Hose into back of pod, until it clicks into place.
For proper operation, ensure all parts are firmly clicked into place.
What are the settings?
Press the Power button to turn the vacuum on or off.
Slide the selector switch to the appropriate surface setting:
Hard Floor
The brushrolls spin slowly to pick up fine dust and large debris on hard floors.
Carpet
The brushrolls spin faster to pick up debris on and below the surface of your carpets.
Suction Control Slider
Increase or decrease suction as needed. Slide to MIN to reduce suction and increase maneuverability on carpets. Slide to MAX to increase suction on bare floors.
What are the cleaning modes?
Upright
To engage brushroll, turn power on, select a surface setting, then step on floor nozzle and
tilt handle back.
Lift-Away
Press Lift-Away Button to lift pod off motorised floor nozzle. You are now ready to clean those hard-to-reach places.
Above Floor
Press the Handle Release Button to detach the handle to clean above-floor areas. Insert
accessories directly into handle.
Above Floor Extended Reach
Press the Wand Release Button to detach the wand to clean with more reach. Insert accessories directly into wand.
Using the Multiflex wand
Press the unlock latch on the back of the wand, then adjust the angle.
Adjust the wand to a lower angle to easily clean under furniture.