When and how do I clean the filters?
Filters may need to be cleaned if the vacuum stops picking up dirt, if airflow is restricted, or if you notice decreased or no suction. For optimal performance, clean filters regularly. Between cleanings, lightly tap filters over a trash receptacle to remove dust and debris as needed.
Rinse the pre-motor foam and felt filters every month, or as needed.
- First, remove the dust cup to access the pre-motor filters.
- Remove the dust cup by pressing the release button on the handheld vacuum, then pulling the dust cup down and away.
- Remove the foam and felt filters using the tab provided.
- Rinse both filters with water only.
- Allow filters to air-dry completely (at least 24 hours) before reinstalling.
- Once dry, install the foam filter first, followed by the felt filter.
- Reinstall the dust cup.
Rinse the post-motor or HEPA filter every 12 months, or as needed.
- Remove the dust cup by pressing the release button on the handheld vacuum, then pulling the dust cup down and away.
- The post-motor filter is attached to a plastic frame inside the handheld vacuum. Press the tabs and pull the filter off the frame.
- Rinse the post-motor filter with water only.
- Allow filter to air-dry completely (at least 24 hours) before reinstalling.
- Once dry, reinstall the post-motor filter.
- Reinstall the dust cup.
When and how do I empty the dust cup?
For optimal performance, empty the dust cup each time you vacuum, or when debris reaches the MAX FILL line.
- Detach the handheld vacuum from the wand by pressing the wand release button.
- Position the dust cup over a trash receptacle, then open the bottom dust cup door by sliding the CleanTouch™ Dirt Ejector slider forward.
- Tap gently to empty contents.
- Wipe the interior of the dust cup clean if desired.
- Close the dust cup door, pressing it until it clicks into place.
How do I access and clean the bristle brushroll?
- Turn the floor nozzle over and use a coin to turn the locks on the bottom cover counterclockwise. Lift off the cover to access the brushroll.
- Clear away any string, hair, or debris wrapped around the brushroll and in the nozzle openings.
- To reattach the bottom cover, press down firmly along all sides. Turn the locks clockwise to close.
