How to assemble
1. Insert wand into pod.
2. Insert handle into wand.
3. Attach hose to back of vacuum pod.
4. Attach hose to clip on wand.
5. Insert C-shaped clip onto base of vacuum pod and remove tape.
6. Store accessories on tool storage posts.
For proper operation, ensure all parts are firmly clicked into place.
What does brushroll indicator light mean?
Solid Green: The brushroll is spinning and working as it should.
Solid Red: There is a jam in the brushroll area. Turn your vacuum off, unplug from the wall and remove any blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn your vacuum off and wait a minimum of 45 minutes for it to cool down.
How to set suction control
Your Suction Control slider located on the top of the handle allows you to adjust your suction depending on your floor type. MIN: to reduce suction and increase maneuverability on carpets. MAX: to increase suction on bare floors.
How to set surface setting
Select surface setting:
O Power Off
I Hard Floor For bare floors and small area rugs.
II Carpet For carpets.
What are the cleaning modes
Upright
To engage brushroll, place foot on floor nozzle and tilt handle back
Above-floor handle
Press the Handle Release button to detach the handle from the wand.
Above-floor wand
Press the Wand Release button to detach the wand from the pod.
Emptying the dust cup
To remove Dust Cup, press button on top of dust cup handle. Tilt dust cup forward, then lift to remove.
Press lower release button to open bottom of dust cup.
To remove collected debris from Lint Screen, press top release button and lift handle to open. Gently brush lint screen to clean.
To reinstall, place bottom of dust cup into pod and then tilt back until it clicks into place.
How to clean filters
Regularly clean and replace your filters to keep your vacuum's suction power optimal. To clean filters, rinse with cold water only to prevent damage from cleaning chemicals. Allow all filters to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electric parts.